76626E
1.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
2.REMOVE REAR QUARTER PANEL MUDGUARD RH
Use the same procedure described for the LH side.
58766A
3.REMOVE JACK BOX HOLE COVER
|
Protective Tape |
Using a screwdriver, detach the 2 claws and remove the jack box hole cover.
Tape the screwdriver tip before use.
52179B
4.REMOVE REAR BUMPER BAR PLATE
|
Protective Tape |
Put protective tape around the rear bumper bar plate.
Detach the 14 claws and remove the rear bumper bar plate.
52162B
5.REMOVE REAR BUMPER NO. 1 PLATE
Remove the 2 bolts.
|
Protective Tape |
Put protective tape around the rear bumper No. 1 plate.
Detach the 21 claws and remove the rear bumper No. 1 plate.
52159
6.REMOVE REAR BUMPER COVER
Remove the 2 clips.
Remove the 3 bolts.
Remove the 2 bolts.
|
Protective Tape |
Put protective tape around the rear bumper cover.
Detach the 7 claws.
Use the same procedure to detach the claw on the other side.
Remove the rear bumper cover as shown in the illustration.
w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
Disconnect the 3 connectors.
w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
disconnect the connector.
w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
disconnect the 2 connectors.
52169A
7.REMOVE REAR BUMPER NO. 3 SIDE SUPPORT
Remove the screw and rear bumper No. 3 side support.
52156A
8.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Using a clip remover, detach the 4 claws and remove the rear bumper side support LH.
Tape the clip remover tip before use.
| *A | for 5 Door | *B | for 3 Door |
| *a | Protective Tape | - | - |
52155A
9.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52174D
10.REMOVE REAR BUMPER BAR REINFORCEMENT LH
Remove the 3 bolts and rear bumper bar reinforcement LH.
52173D
11.REMOVE REAR BUMPER BAR REINFORCEMENT RH
Use the same procedure described for the LH side.
52158C
12.REMOVE REAR BUMPER NO. 2 SIDE SUPPORT LH
Remove the bolt and rear bumper No. 2 side support LH.
52186B
13.REMOVE REAR BUMPER SIDE MOUNTING BRACKET LH
w/ Entry and Start System:
Disconnect the connector.
Remove the bolt and rear bumper side mounting bracket LH.
52185B
14.REMOVE REAR BUMPER SIDE MOUNTING BRACKET RH
Use the same procedure described for the LH side.
89997
15.REMOVE ELECTRICAL KEY ANTENNA (w/ Entry and Start System)
Remove the bolt and electrical key antenna.