When the radiator grille is damaged or deformed due to an accident or contact with other objects, etc., or the radiator grille installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
53111
1.INSTALL RADIATOR GRILLE
w/ Multi-terrain Monitor:
Connect the connector.
w/ Toyota Safety Sense P:
Connect the connector.
Attach the 6 claws to install the radiator grille.
Install the 4 screws.
Attach the 2 clips to install the hood to radiator grille seal.
Use the same procedure for the RH side.
53148A
2.INSTALL HEADLIGHT ORNAMENT GARNISH LH (for Halogen Headlight)
|
Protective Tape |
Attach the 4 clips to install the headlight ornament garnish LH.
Remove the protective tape.
53147A
3.INSTALL HEADLIGHT ORNAMENT GARNISH RH (for Halogen Headlight)
Use the same procedure described for the LH side.
53148A
4.INSTALL HEADLIGHT ORNAMENT GARNISH LH (for LED Headlight)
|
Protective Tape |
Attach the 8 clips to install the headlight ornament garnish LH.
Remove the protective tape.
53147A
5.INSTALL HEADLIGHT ORNAMENT GARNISH RH (for LED Headlight)
Use the same procedure described for the LH side.
53292A
6.INSTALL UPPER RADIATOR SUPPORT SEAL
86790B
7.ADJUST FRONT TELEVISION CAMERA ASSEMBLY
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>CALIBRATION
When only the radiator grille is removed and reinstalled, it is not necessary to adjust the front television camera assembly.(Such as when removing or installing the radiator grille in order to remove or install the headlight assembly.)