87290
1.INSPECT HEATER SWITCH ASSEMBLY
Check resistance.
| *a | Component without harness connected
(Heater Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (IG) - 2 (IN) | Heater switch assembly off | 10 kΩ or higher |
| Heater switch assembly on | Below 1 Ω |
If the result is not as specified, there may be a malfunction in the heater switch assembly.
Check that the Indicator.
| *a | Component without harness connected
(Heater Switch Assembly) |
| *b | Indicator |
Apply battery voltage to the connector and check the Indicator.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 2 (IN)
Battery negative (-) → 4 (E) |
Indicator illuminates |
If the result is not as specified, there may be a malfunction in the heater switch assembly.
Check that the illumination.
| *a | Component without harness connected
(Heater Switch Assembly) |
Apply battery voltage to the connector and check the illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-) |
Heater switch assembly illuminates |
If the result is not as specified, there may be a malfunction in the heater switch assembly.
84453
2.INSPECT IDLE UP SWITCH
| *a | Component without harness connected
(Idle Up Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (SW) - 3 (E) | Idle up switch off | 10 kΩ or higher |
| Idle up switch on | Below 1 Ω |
Apply battery voltage to the connector and check the LED illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 5 (ILL+)
Battery negative (-) → 4 (ILL-) |
LED illuminates |
If the result is not as specified, there may be a malfunction in the idle up switch.