84711
1.INSPECT ECO MODE SWITCH (Drive Mode)
Remove the eco mode switch.
Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH>REMOVAL
for 5 mode type:
| *a | Component without harness connected
(Eco Mode Switch (Drive Mode)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 - 5 | COMF ECO mode switch pushed and held | Below 10 Ω |
| COMF ECO mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, there may be a malfunction in the eco mode switch (Drive Mode).
for 3 mode type:
| *a | Component without harness connected
(Eco Mode Switch (Drive Mode)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 - 5 | ECO mode switch pushed and held | Below 10 Ω |
| ECO mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, there may be a malfunction in the eco mode switch (Drive Mode).
| *a | Component without harness connected
(Eco Mode Switch (Drive Mode)) |
Apply battery voltage between the terminals of the eco mode switch (Drive Mode), and check the illumination condition of the eco mode switch (Drive Mode).
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) - 1
Battery negative (-) - 10 |
Illuminates |
If the result is not as specified, there may be a malfunction in the eco mode switch (Drive Mode).
Install the eco mode switch.
Click hereDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH>INSTALLATION