Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
52119A
1.REMOVE FRONT BUMPER COVER
89341K
2.REMOVE FRONT CORNER ULTRASONIC SENSOR
Use the same procedure to remove the front corner ultrasonic sensor on the other side.
Disconnect the connector.
Detach the 2 claws and remove the front corner ultrasonic sensor.
Before removing the ultrasonic sensor, make sure to mark the ultra sonicsensor and front bumper cover so that each ultrasonic sensor can be returned to its original position.
89347B
3.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER
Use the same procedure to remove the front corner ultrasonic sensor retainer on the other side.
Using a heat light, heat the front bumper cover.
| Item | Temperature |
|---|---|
| Front Bumper Cover | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front bumper cover excessively.
Remove the front corner ultrasonic sensor retainer.
89341L
4.REMOVE FRONT CENTER ULTRASONIC SENSOR
Use the same procedure described for the front corner ultrasonic sensor.
89347C
5.REMOVE FRONT CENTER ULTRASONIC SENSOR RETAINER
Use the same procedure described for the front corner ultrasonic sensor retainer.