Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE SONAR MAIN SWITCH › from 2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0260995 CLEARANCE SONAR MAIN SWITCH G

PARK ASSIST / MONITORING  CLEARANCE SONAR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490A 1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

E377033C06
1.969,1.135 2.51,0.615 true 1.479,1.146 0.844,0.635 true 1.635,1.844 1.635,1.281 true 0.896,1.823 1.302,1.281 true 2.531,1.802 2.135,1.292 true 0.125,0.083 0.438,0.281 0.313,0.198 10 false *a 2.573,0.552 3.031,0.75 0.458,0.198 10 false ECU 0.656,0.552 0.938,0.76 0.281,0.208 10 false IG 1.573,1.865 1.854,2.073 0.281,0.208 10 false IND 0.802,1.833 1.156,2.052 0.354,0.219 10 false ILL+ 2.49,1.813 2.844,2.031 0.354,0.219 10 false ILL-
*a Component without harness connected
(Back Sonar or Clearance Sonar Switch)


a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (ECU) - 5 (IG) Back sonar or clearance sonar switch off 10 kΩ or higher
Back sonar or clearance sonar switch on Below 1 Ω


If the result is not as specified, replace the back sonar or clearance sonar switch.



b.

Apply battery voltage to the connector and check the the indicator operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 2 (ECU)
Battery negative (-) → Terminal 4 (IND)
LED illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch.


c.

Apply battery voltage to the connector and check the LED illumination.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
LED illuminates


If the result is not as specified, replace the back sonar or clearance sonar switch.