Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261094 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 45187 2.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B238307

Detach the 2 claws and remove the cover.


Hide 45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B238308E01
0.11,0.036 0.303,0.251 0.193,0.214 10 *A 0.108,2.079 0.301,2.293 0.193,0.214 10 *B

Detach the 2 claws and remove the cover.

Text in Illustration
*A w/o Cruise Control System
*B w/ Cruise Control System


Hide 45130 4.REMOVE STEERING PAD

a.

Using a T25H "TORX" driver, push in the torsion spring to detach the 3 pins and remove the steering pad.

NOTICE:
·

Do not drop the steering pad.

·

When disconnecting the steering pad, do not pull the airbag wire harness.



HINT:

Insert the T25H "TORX" screwdriver into the installation areas of the lower No. 2 steering wheel cover and lower No. 3 steering wheel cover.


B427360


b.
B420300E01
0.792,2.802 1.51,3.042 true 1.573,3 1.802,3.198 0.229,0.198 10 false *a

Tilt the steering pad toward the seat and support it with one hand.


c.

Disconnect the horn connector.


d.

Using a screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*a Connector Lock
V100155

Protective Tape

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


HINT:
·

Use the same procedure to disconnect the airbag connector on the other side.

·

Tape the screwdriver tip before use.