Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2017.08–2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260747 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM illuminates the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control indicator illuminates when the cruise control system is turned on using the cruise control main switch (ON-OFF button).

·

w/ Multi-information Display:

The cruise control indicator light illuminates when the cruise control system has been turned on using the cruise control main switch (ON/OFF). If a malfunction is detected, the cruise control indicator light goes off and a warning message is displayed.

·

w/o Multi-information Display:

The cruise control indicator light in the combination meter assembly changes to yellow when a malfunction occurs during cruise control driving.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

Before replacing the ECM refer to Service Bulletin.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

w/ Multi-information Display:

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test

Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -

OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation



f.

w/o Multi-information Display:

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test

Tester Display Measurement Item Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise indicator light OFF or ON -

OK:

Cruise control indicator light turns ON/OFF



Result:
Result Proceed to
OK A
NG B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

for 1GR-FE (for Manual Transmission):

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List

Tester Display Measurement Item Range Normal Condition Diagnostic Note
CCS Ready M-CPU Cruise control system standby condition (Main CPU) ON or OFF ON: Cruise control main switch on
OFF: Cruise control main switch off
-
CCS Indicator M-CPU Cruise control indicator light signal (Main-CPU) ON or OFF ON: Cruise main indicator light on
OFF: Cruise main indicator light off
-


c.

except 1GR-FE (for Manual Transmission):

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List

Tester Display Measurement Item Range Normal Condition Diagnostic Note
Cruise Ready Main-CPU Cruise control system standby condition ON or OFF Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes -
Cruise Ready Sub-CPU Cruise control system standby condition ON or OFF Each time cruise control main switch (ON/OFF button) is pushed, ON or OFF changes -
Cruise Indicator Cruise control indicator status ON or OFF ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off
-


Result:
Result Proceed to
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch (ON-OFF button). A
The cruise control indicator does not illuminate but the Data List item Cruise Indicator changes according to the operation of the cruise control main switch (ON-OFF button). B
The cruise control indicator does not illuminate and the Data List item Cruise Indicator does not change according to the operation of the cruise control main switch (ON-OFF button). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C