Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260920 DOWNHILL ASSIST CONTROL SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DOWNHILL ASSIST CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84988H 1.INSPECT DOWNHILL ASSIST CONTROL SWITCH

a.
C381450C03
1.177,1.958 1.344,1.958 1.344,1.958 1.344,1.292 true 2.198,1.948 2.031,1.948 2.031,1.948 2.031,1.281 true 0.833,1.854 1.292,2.073 0.458,0.219 10 false +B2 2.271,1.844 2.615,2.063 0.344,0.219 10 false E 0.177,0.125 0.521,0.344 0.344,0.219 10 false *a
*a Component without harness connected
(Downhill Assist Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (E) - 5 (+B2) ON Below 1 Ω
OFF 10 kΩ or higher


If the result is not as specified, replace the downhill assist control switch.


b.
C381450C04
0.927,1.885 1.094,1.885 1.094,1.885 1.094,1.302 true 2.406,1.875 2.24,1.875 2.24,1.875 2.24,1.292 true 0.594,1.781 1.063,2.052 0.469,0.271 10 false +ILL 2.469,1.771 2.875,2.01 0.406,0.24 10 false -ILL 0.104,0.115 0.51,0.354 0.406,0.24 10 false *a
*a Component without harness connected
(Downhill Assist Control Switch)


Apply battery voltage between the terminals of the downhill assist control switch, and check the illumination condition of the downhill assist control switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 6 (+ILL)
Battery negative (-) → 1 (-ILL)
Illuminates


If the result is not as specified, replace the downhill assist control switch.