Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY › 2017.08–2020.08
RM27T0E _57 Power Source / Network _053728 POWER DISTRIBUTION _0328752 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 82662A 2.REMOVE NO. 1 RELAY BLOCK COVER

a.
E379431C01
1.563,0.969 1.563,0.635 true 1.469,0.958 1.667,1.135 0.198,0.177 10 false *a
*a Lock


Push the lock to detach the No. 1 relay block cover.


b.

Detach the 2 claws while lifting up the No. 1 relay block cover to remove it.


Hide 82641 3.REMOVE NO. 1 INTEGRATION RELAY

a.

except 5L-E:

i.
E379430C01
2.375,0.948 2.74,0.948 true 1.625,1.25 1.625,1.698 true 2.75,0.854 2.948,1.021 0.198,0.167 10 true *a 1.531,1.688 1.729,1.854 0.198,0.167 10 false *a
*a No. 1 Integration Relay Fixing Lock


While pushing the No. 1 integration relay fixing lock shown in the right illustration toward the center, pull the No. 1 integration relay upwards.


ii.
E378099

Disconnect the 5 connectors from the No. 1 integration relay and remove it.

NOTICE:

Do not drop the No. 1 integration relay or subject it to any strong impacts. Additionally, do not use a No. 1 integration relay that has been dropped.




b.

for 5L-E:

i.
B236388C04
1.323,0.167 1.063,0.167 1.063,0.167 0.656,0.313 false 2.229,0.146 2.438,0.146 2.438,0.146 2.865,0.281 false 1.354,0.063 1.531,0.219 0.177,0.156 10 false *a 2.063,0.063 2.24,0.219 0.177,0.156 10 false *a
*a Protective Tape


Using a screwdriver, detach the 2 claws and disconnect the No. 1 integration relay from the engine room junction block.

HINT:

Tape the screwdriver tip before use.