This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the entry and start system (for Entry Function) related items that are customizable via the navigation receiver assembly screen.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15F7 | Certification ECU (smart key ECU assembly) vehicle setting processing error. | ·
CAN communication system ·
Entry and start system (for Entry Function) ·
Certification ECU (smart key ECU assembly) ·
Navigation receiver assembly |
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).
Use the GTS to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING).
CAN communication DTCs are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Check if the entry and start system (for Entry Function) is malfunctioning (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING).
Customization may not be possible depending on the malfunction in the entry and start system (for Entry Function).
No malfunctions are present in the entry and start system (for Entry Function).
OK
NG
Display the "Vehicle Customization" screen.
Make a note of the customizable items for each certification ECU (smart key ECU assembly) related system.
These items shown as customizable via the audio and visual system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.
Check the customize parameters list for the entry and start system (for Entry Function) related items that can be customized via the navigation receiver assembly screen (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>CUSTOMIZE PARAMETERS).
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the navigation receiver assembly screen.
The items available for customization via the navigation receiver assembly screen can be customized successfully using the manual procedure.
OK
NG