84970
1.INSPECT COMBINATION SWITCH ASSEMBLY (REAR DIFFERENTIAL LOCK CONTROL SWITCH)
| *a | Component without harness connected
Combination Switch Assembly (Rear Differential Lock Control Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (B) - 2 (E) | ON | Below 1 Ω |
| OFF | 10 kΩ or higher |
If the result is not as specified, replace the combination switch assembly (rear differential lock control switch).
| *a | Component without harness connected
Combination Switch Assembly (Rear Differential Lock Control Switch) |
Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly (rear differential lock control switch).
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the combination switch assembly (rear differential lock control switch).