Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL LOCK CONTROL SWITCH(w/o Combination Switch) › from 2017.08
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0260869 REAR DIFFERENTIAL LOCK CONTROL SWITCH(w/o Combination Switch) G

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL LOCK CONTROL SWITCH(w/o Combination Switch)  INSPECTION  


PROCEDURE

Hide 84725A 1.INSPECT DIFFERENTIAL LOCK SWITCH

a.
C375581C01
1.167,1.885 1.333,1.885 1.333,1.885 1.333,1.302 true 2.177,1.885 2.01,1.885 2.01,1.885 2.01,1.302 true 1,1.802 1.208,2.021 0.208,0.219 10 false B 2.219,1.813 2.438,2.021 0.219,0.208 10 false E 0.125,0.104 0.438,0.302 0.313,0.198 10 false *a
*a Component without harness connected
(Rear Differential Lock Control Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (B) - 2 (E) ON Below 1 Ω
OFF 10 kΩ or higher


If the result is not as specified, replace the rear differential lock control switch.


b.
C375581C02
0.948,1.885 1.115,1.885 1.115,1.885 1.115,1.302 true 2.427,1.885 2.26,1.885 2.26,1.885 2.26,1.302 true 0.615,1.781 1.031,2.01 0.417,0.229 10 false +ILL 2.469,1.781 2.885,1.99 0.417,0.208 10 false -ILL 0.167,0.104 0.479,0.302 0.313,0.198 10 false *a
*a Component without harness connected
(Rear Differential Lock Control Switch)


Apply battery voltage between the terminals of the rear differential lock control switch, and check the illumination condition of the rear differential lock control switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 6 (+ILL)
Battery negative (-) → 1 (-ILL)
Illuminates


If the result is not as specified, replace the rear differential lock control switch.