Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0260992 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Data Signal Circuit between Stereo Jack Adapter and Extension Module  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation ECU via this circuit.

WIRING DIAGRAM

E281004E28
5.146,1.771 5.927,1.917 0.781,0.146 10 false A 5.146,1.917 6.458,2.271 1.313,0.354 10 false Navigation ECU 0.917,1.771 1.385,1.958 0.469,0.188 10 false H85 0.917,1.917 2.583,2.292 1.667,0.375 10 false No. 1 Stereo Jack Adapter Assembly 5,0.646 5.188,0.792 0.188,0.146 10 false 2 5.188,0.75 6.104,0.896 0.917,0.146 10 false US1- 5.177,1.281 6.094,1.427 0.917,0.146 10 false US1+ 1.594,0.75 2,0.948 0.406,0.198 10 false UDO- 1.573,1.281 1.99,1.479 0.417,0.198 10 false UDO+ 5,1.177 5.188,1.323 0.188,0.146 10 false 3 2.073,0.667 2.26,0.833 0.188,0.167 10 false 9 2.073,1.219 2.292,1.385 0.219,0.167 10 false 10

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the A navigation ECU connector.


b.

Disconnect the H85 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 (US1-) - H85-9 (UDO-) Always Below 1 Ω
A-3 (US1+) - H85-10 (UDO+) Always Below 1 Ω
A-2 (US1-) - Body ground Always 10 kΩ or higher
A-3 (US1+) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR