Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › from 2017.08
RM27T0E _58 Vehicle Interior _053738 SEAT BELT _0261145 SEAT BELT WARNING SYSTEM Y

SEAT BELT  SEAT BELT WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the front power seat control system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same CAN communication system DTC or airbag system DTC by simulating the symptoms indicated by the DTC.


Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output (w/ Central Gateway ECU) B
CAN DTC is output (w/o Central Gateway ECU) C
Airbag system DTC is output D



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

4.PROBLEM SYMPTOMS TABLE
a.

Result:
Proceed to
NEXT



NEXT

5.OVERALL ANALYSIS AND TROUBLESHOOTING*
5.OVERALL ANALYSIS AND TROUBLESHOOTING*



d.

Inspection


Result:
Proceed to
NEXT



NEXT

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END