The warning indicator lights are installed in the clearance warning indicator assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G160 clearance warning indicator assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G160-10 (BD) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Clearance Warning Indicator Assembly) |
OK
NG
Disconnect the I8 clearance warning ECU connector.
Disconnect the G160 clearance warning indicator light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I8-7 (L1) - G160-5 (RR) | Always | Below 1 Ω |
| I8-8 (L2) - G160-13 (RL) | Always | Below 1 Ω |
| I8-23 (L3) - G160-14 (BK) | Always | Below 1 Ω |
| I8-10 (L10) - G160-6 (OP) | Always | Below 1 Ω |
| I8-7 (L1) - Body ground | Always | 10 kΩ or higher |
| I8-8 (L2) - Body ground | Always | 10 kΩ or higher |
| I8-23 (L3) - Body ground | Always | 10 kΩ or higher |
| I8-10 (L10) - Body ground | Always | 10 kΩ or higher |
OK
NG