Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Multi-display) › from 2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261004 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display)  Taillight Relay Circuit  


WIRING DIAGRAM

E199662E05
0.604,1.021 1.823,1.208 1.219,0.188 10 false from PANEL Fuse 5.75,1.021 6.063,1.208 0.313,0.188 10 false TL 5.344,0.896 5.542,1.063 0.198,0.167 10 false 20 5.458,1.771 5.729,1.938 0.271,0.167 10 false I8 5.417,1.938 6.969,2.135 1.552,0.198 10 false Clearance Warning ECU

PROCEDURE

1.CHECK TAILLIGHT
a.

Turn the light control switch to the TAIL position.


b.

Check that the taillight turns on.

OK:

Taillight turns on.




OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)

NG

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)
a.
E379203E01
1.573,0.417 1.917,0.656 0.344,0.24 0.177,0.115 0.49,0.313 0.313,0.198 10 false *a 1.688,0.458 2,0.656 0.313,0.198 10 false I8

Disconnect the I8 clearance warning ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I8-20 (TL) - Body ground Ignition switch ON, light control switch TAIL position 7 V or higher
Ignition switch ON, light control switch not TAIL position Below 1.5 V


Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR