The clearance warning buzzer sounds to alert the driver. The sounding pattern changes according to the distance to the obstacle.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the I8 clearance warning ECU connector.
Disconnect the G161 No. 1 clearance warning buzzer connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I8-1 (BBZ) - G161-1 (Z+) | Always | Below 1 Ω |
| I8-2 (ER) - G161-2 (Z-) | Always | Below 1 Ω |
| I8-1 (BBZ) - Body ground | Always | 10 kΩ or higher |
| I8-2 (ER) - Body ground | Always | 10 kΩ or higher |
OK
NG