This circuit is the power source circuit used to operate the clearance warning ECU.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the I8 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I8-11 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| I8-11 (IG) - Body ground | Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I8-16 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Clearance Warning ECU) |
OK
NG