Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261082 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0129  Lost Communication with Skid Control ECU  U0131  Lost Communication with Power Steering Control Module  U0142  Lost Communication with Main Body ECU  U0151  Lost Communication with Airbag ECU  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
U0100* Both conditions are met:
·

The voltage at the IG power supply terminal of the combination meter assembly is between 9.5 and 11.5 V.

·

No communication with the ECM continues for 2 seconds or more.


·

ECM

·

CAN communication system

·

Combination meter assembly


U0129 Both conditions are met:
·

The voltage at the IG power supply terminal of the combination meter assembly is between 9.5 and 11.5 V.

·

No communication with the skid control ECU continues for 3 seconds or more.


·

Skid control ECU

·

CAN communication system

·

Combination meter assembly


U0131*2 Both conditions are met:
·

The voltage at the IG power supply terminal of the combination meter assembly is between 9.5 and 11.5 V.

·

No communication with the power steering ECU assembly continues for 3 seconds or more.


·

Power steering ECU assembly

·

CAN communication system

·

Combination meter assembly


U0142*3 Both conditions are met:
·

The voltage at the IG power supply terminal of the combination meter assembly is between 9.5 and 11.5 V.

·

No communication with the main body ECU (multiplex network body ECU) continues for 3 seconds or more.


·

Main body ECU (multiplex network body ECU)

·

CAN communication system

·

Combination meter assembly


U0151 Both conditions are met:
·

The voltage at the IG power supply terminal of the combination meter assembly is between 9.5 and 11.5 V.

·

No communication with the center airbag sensor assembly continues for 10 seconds or more.


·

Center airbag sensor assembly

·

CAN communication system

·

Combination meter assembly



*1: except 5L-E

*2: w/ Power Steering System, VSC

*3: for Optitron Meter


PROCEDURE

1.CONFIRM DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Trouble Codes.


e.

Clear the stored DTCs.


f.

Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.


g.

Stop the vehicle.


h.

Check for DTCs (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output (w/ Central Gatway ECU) B
CAN communication system DTC is output (w/o Central Gatway ECU) C

HINT:

If CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 first.




A

B

C