Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2017.08–2020.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261082 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  OPERATION CHECK  


CHECK INDICATOR/WARNING LIGHT


a.

Check the following indicators and warning lights.

Indicator/Warning Light Switch Condition Specified Condition
Brake warning light Ignition switch off → ON Comes on for 3 seconds
ABS warning light
SLIP indicator light
TRC OFF indicator light
VSC OFF indicator light
CRAWL indicator light
Downhill assist control indicator light
KDSS indicator light
Eco driving indicator Light
Oil maintenance warning light
OIL level indicator light
T-BELT indicator light
SEDIMENTER/FUEL FILTER indicator light
SEDIMENTER indicator light
SPEED LIMIT indicator light
PCS indicator light
PPS warning light
Master warning light
BSM indicator light
Headlight beam level control system warning light
LED headlight warning light
Tire pressure warning light
Diesel particulate filter warning light
SRS warning light Ignition switch off → ON Comes on for 6 seconds
CHARGE warning light Ignition switch off → ON
·

Illuminates when ignition switch turned to ON

·

Turns off when engine started


OIL PRESSURE warning light
A/T OIL TEMP warning light
MIL
SIL indicator light



CHECK SPEEDOMETER


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List.

Reference:
for mph
Standard Indication (mph) Acceptable Range (mph)
20 21 to 23.5
40 42 to 44.5
60 62.5 to 66
80 83.1 to 87.1
100 103.9 to 108.4

for km/h (except Australia)
Standard Indication (km/h) Acceptable Range (km/h)
20 21 to 25
40 41.7 to 46.2
60 62.7 to 67.2
80 83.4 to 88.4
100 104.3 to 109.3
120 125.1 to 130.6
140 145.8 to 151.8
160 166.2 to 173.2
180 186.9 to 194.5

for km/h (for Australia)
Standard Indication (km/h) Acceptable Range (km/h)
20 20.4 to 24.4
40 40.8 to 45.3
60 61.2 to 65.7
80 81.5 to 86.5
100 101.9 to 105.9
120 122.3 to 127.3
140 142.7 to 147.7
160 163.1 to 168.1
180 183.5 to 188.5


If the result is not as specified, the speedometer may have a malfunction.

NOTICE:

Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.



e.

Check the deflection width of the speedometer indicator.

Reference:

Within 0.3°




CHECK TACHOMETER


a.

Connect a tune-up tachometer and start the engine.


b.

Compare the test results with the tachometer indicator.

DC 13.5 V at 25°C (77°F):
Standard Indication (rpm) Acceptable Range Data in ( ) is for Reference (rpm)
700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000* (5750 to 6250)


*: for Gasoline Engine


If the result is not as specified, the tachometer may have a malfunction.



CHECK METER/GAUGE


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

OK:

Each meter/gauge needle indication is normal.




CHECK WARNING/INDICATOR LIGHT


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

OK:

Each warning/indicator light can be turned on and off using the GTS.




CHECK MULTI-INFORMATION DISPLAY (for Segment Display Type [except 5L-E])


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

OK:

All segments in the multi-information display can be turned on and off using the GTS.




CHECK MULTI-INFORMATION DISPLAY (for TFT Display Type)


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

OK:

All dots in the multi-information display can be turned on and off using the GTS.