Home › Engine / Hybrid System › 1GD-FTV (STARTING) › ENGINE SWITCH (for RHD) › from 2017.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260745 ENGINE SWITCH(for RHD) G

1GD-FTV STARTING  ENGINE SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE SWITCH

a.
B268088C25
1.24,1.156 0.76,0.948 true 2.156,1.167 2.625,0.948 true 2.625,1.677 2.156,1.458 true 0.094,0.083 0.385,0.25 0.292,0.167 10 false *a 0.5,0.844 0.854,1.01 0.354,0.167 10 false SS1 2.667,0.865 3.031,1.031 0.365,0.167 10 false SS2 2.667,1.635 3.125,1.823 0.458,0.188 10 false AGND
*a Component without harness connected
(Engine Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (SS1) - 6 (AGND)
1 (SS2) - 6 (AGND)
Not pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the engine switch.


b.
B268088C26
1.479,1.479 1.26,1.844 true 2.625,1.667 2.156,1.448 true 0.094,0.083 0.417,0.25 0.323,0.167 10 false *a 1.094,1.854 1.646,2.063 0.552,0.208 10 false SWIL 2.656,1.635 3.115,1.802 0.458,0.167 10 false AGND
*a Component without harness connected
(Engine Switch)


Apply battery voltage between the terminals of the engine switch, and check the illumination condition of the engine switch indicator light.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the engine switch indicator light will not illuminate.



If the result is not as specified, replace the engine switch.