Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260912 VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)  C1442  Invalid Data Received from Deceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.

The yaw rate and acceleration sensor has a built-in airbag sensor assembly and detects the vehicle condition.

DTC Code DTC Detection Condition Trouble Area
C1442 An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. Acceleration sensor (Airbag sensor assembly)
C1443 An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more. Yaw rate sensor (Airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>CALIBRATION).


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.



c.

Start the engine and idle it for 60 seconds, and then stop the engine.


d.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

B