The skid control ECU (brake actuator assembly) receives signals from the ECM, the steering sensor and the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0073 | One of the following conditions is met:
1.
When the IG1 terminal voltage is between 10 and 17.4 V, after the output of data from the skid control ECU (brake actuator assembly) is completed, the sending operation continues for 5 seconds or more. 2.
The condition that the bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession (sent signals cannot be received). 3.
When the IG1 terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate and acceleration sensor (airbag sensor assembly) and steering sensor continues for 1 second or more. 4.
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that a delay in receiving data from the yaw rate and acceleration sensor (airbag sensor assembly) and steering sensor occurs more than once within 5 seconds. |
CAN communication system |
| U0100 | Either condition is met:
1.
When the IG1 terminal voltage is between 10 and 17.4 V and the vehicle speed is 15 km/h (9 mph) or more, data cannot be sent to the ECM for 2 seconds or more. 2.
When the IG1 terminal voltage is between 10 and 17.4 V and the vehicle speed is 15 km/h (9 mph) or more, data cannot be received from the ECM for 2 seconds or more. |
CAN communication system |
| U0114 | The CAN signal from the 4 wheel drive control ECU is lost or malfunctioning for 1.2 seconds. | CAN communication system |
| U0123 | Either condition is met:
1.
When the IG1 terminal voltage is between 10 and 17.4 V, data from the yaw rate sensor cannot be received for 1 second or more. 2.
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that data from the yaw rate sensor (airbag sensor assembly) cannot be received occurs once or more within 5 seconds. |
CAN communication system |
| U0124 | Either condition is met:
1.
When the IG1 terminal voltage is between 10 and 17.4 V, data from the acceleration sensor (airbag sensor assembly) cannot be received for 1 second or more. 2.
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that data from the acceleration sensor (airbag sensor assembly) cannot be received occurs once or more within 5 seconds. |
CAN communication system |
| U0126 | Either condition is met:
1.
When the IG1 terminal voltage is between 10 and 17.4 V, data from the steering sensor cannot be received for 1 second or more. 2.
When the IG1 terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession. -
The condition that data from the steering sensor cannot be received occurs once or more within 5 seconds. |
CAN communication system |
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Vacuum Brake Booster)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC not output | A |
| DTC output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B