Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260910 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1419  Acceleration Sensor Internal Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the acceleration sensor (airbag sensor assembly) via the CAN communication system.

The acceleration sensor (airbag sensor assembly) detects the vehicle's condition using 2 circuits (GL1, GL2).

If there is trouble in the bus lines between the acceleration sensor (airbag sensor assembly) and the CAN communication system, DTC U0124 (malfunction in CAN communication with the acceleration sensor) are stored.

This DTC is also stored when calibration is not completed.

DTC Code DTC Detection Condition Trouble Area
C1419 A data malfunction signal is received from the acceleration sensor. Acceleration sensor (Airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the acceleration sensor (airbag sensor assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).


HINT:

When DTC U0124 is output together with DTC C1419, inspect and repair the trouble areas indicated by DTC U0124 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>U0073).


PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY
a.

Replace the acceleration sensor (airbag sensor assembly) (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL).



NEXT

END