This DTC indicates a malfunction in the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0575 | Cruise Control Input Circuit | ·
When the ignition switch is turned to ON, STP signals input to the ECM supervisory CPU and control ECU are different for approximately 0.2 seconds or more. ·
While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled approximately 0.4 seconds have passed after cruise cancel input signal (STP input) is input to the ECM. |
ECM |
Before replacing the ECM, refer to Service Bulletin.
The ECM receives signals from each sensor to control all the functions of the dynamic radar cruise control system with the supervisory CPU and control ECU. When a malfunction is detected, the fail-safe remains on until the ignition switch is turned off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P0575 is not output | A |
| DTC P0575 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
for 1GR-FE: Click hereEngine / Hybrid System>1GR-FE (ENGINE CONTROL)>ECM>REMOVAL
for 1KD-FTV: Click hereEngine / Hybrid System>1KD-FTV (ENGINE CONTROL)>ECM>REMOVAL
for 1GD-FTV: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL
for 2TR-FE: Click hereEngine / Hybrid System>2TR-FE (ENGINE CONTROL)>ECM>REMOVAL