These DTCs are output when a communication malfunction occurs between the sensors and ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0101 | Lost Communication with TCM | 2 seconds after the ignition switch is turned ON, the vehicle is being driven at 1 km/h (1 mph) or more, a communication error between the ECM and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
ECM ·
Forward recognition camera |
| U0123 | Lost Communication with Yaw Rate Sensor Module | 2 seconds after the ignition switch is turned ON, the vehicle is being driven at 1 km/h (1 mph) or more and a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate sensor (airbag sensor assembly) ·
Forward recognition camera |
| U0126 | Lost Communication With Steering Angle Sensor Module | 2 seconds after the ignition switch is turned ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Steering sensor ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | 2 seconds after the ignition switch is turned ON, a communication error between the skid control ECU and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
skid control ECU (brake actuator assembly*1 or master cylinder solenoid*2) ·
Forward recognition camera |
| U0142 | Lost Communication with Body Control Module "B" | 2 seconds after the ignition switch is turned ON, a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Main body ECU (Multiplex network body ECU) ·
Forward recognition camera |
| U0155 | Lost Communication with Combination Meter | 2 seconds after the ignition switch is turned ON, a communication error between the combination meter assembly and the forward recognition camera is detected for approximately 50 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Forward recognition camera |
*1: for 2TR-FE
*2: except 2TR-FE
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the conditions are not met, the system cannot detect the malfunction.
Check the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0101, U0123, U0126, U0129, U0142 and U0155 are not output | A |
| DTC U0101, U0123, U0126, U0129, U0142 or U0155 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B