Home › Engine / Hybrid System › CRUISE CONTROL › FORWARD RECOGNITION CAMERA SYSTEM › 2017.08–2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0332059 FORWARD RECOGNITION CAMERA SYSTEM J

CRUISE CONTROL  FORWARD RECOGNITION CAMERA SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the forward recognition camera.

WIRING DIAGRAM

E240004E25
0.427,0.698 1.469,0.99 1.042,0.292 10 false from IG Circuit 2.844,0.875 3.854,1.083 1.01,0.208 10 false ECU-IG NO. 1 5,0.698 5.479,0.979 0.479,0.281 10 false IGB 4.979,1.594 5.438,1.813 0.458,0.219 10 false GND 4.792,0.583 5.375,0.792 0.583,0.208 10 false 7 4.563,1.979 4.917,2.198 0.354,0.219 10 false W22 4.573,2.125 6.833,2.271 2.26,0.146 10 false Forward Recognition Camera 4.719,1.49 5.302,1.698 0.583,0.208 10 false 10

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)
a.
E374719C05
0.552,1.042 0.958,1.323 0.406,0.281 1.281,1.396 0.969,1.76 true 0.625,1.094 1.083,1.292 0.458,0.198 10 false W22 0.688,1.729 1.302,1.927 0.615,0.198 10 false IGB 0.125,0.094 0.458,0.333 0.333,0.24 10 false *a
*a Front view of wire harness connector
(to Forward Recognition Camera)


Disconnect the W22 forward recognition camera connector.


b.

Turn the ignition switch to ON.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
W22-7 (IGB) - Body ground Ignition switch ON 11 to 14 V



d.

Turn the ignition switch off.


e.

Connect the W22 forward recognition camera connector.


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)
a.

Disconnect the W22 forward recognition camera connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W22-10 (GND) - Body ground Always Below 1 Ω



c.

Connect the W22 forward recognition camera connector


Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR