Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL LOCK ACTUATOR › from 2017.08
RM27T0E _52 Drivetrain _053705 AXLE AND DIFFERENTIAL _0333851 REAR DIFFERENTIAL LOCK ACTUATOR A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL LOCK ACTUATOR  INSTALLATION  


PROCEDURE

Hide 41450 1.INSTALL DIFFERENTIAL LOCK SHIFT ACTUATOR

R008153E06
1.125,1.156 2.01,1.156 false 1.26,1.656 1.802,1.573 false 2.115,0.74 2.615,0.917 0.5,0.177 10 false *a 2.042,1.063 2.677,1.24 0.635,0.177 10 false *1 1.844,1.5 2.052,1.667 0.208,0.167 10 false *2

a.

Check that the outermost rack tooth of the shift fork is approximately above the center line of the actuator installation hole.

Text in Illustration
*1 Shift Fork
*2 Actuator Installation Hole
*a Outside


b.
C358697E01
2.719,0.969 3.333,1.167 0.615,0.198 10 false 1.5V 1.885,2.458 2.5,2.656 0.615,0.198 10 false 5° 2.031,2.906 2.646,3.104 0.615,0.198 10 false *a 2.323,3.396 2.938,3.594 0.615,0.198 10 false *b 0.896,3.083 1.51,3.281 0.615,0.198 10 false 108°

Make sure that the matchmarks on the pinion of the actuator are in the range of 0 to 5 degrees clockwise from the center line of the actuator.

Text in Illustration
*a Matchmark
*b Groove

NOTICE:
·

If the matchmarks are not within this range, rotate the pinion.

·

Do not apply positive battery voltage directly to the terminals.

·

If the matchmarks move to the limit of rotation, stop applying electric current.




c.

Install a new O-ring to the actuator.


d.

Apply a light coat of gear oil to the O-ring.


e.

Apply MP grease to the gear.


f.
G020288E03
0.823,0.406 1.302,0.417 false 1.333,0.333 2.042,0.531 0.708,0.198 11 false *1

Mack sure that the outermost rack tooth of the shift fork aligns with the matchmarks on the pinion of the actuator.


g.

Install the actuator so that the knock pin on the carrier side fits into the long hole on the actuator side.

Text in Illustration
*a Knock Pin

HINT:

Do not damage the O-ring of the actuator.



h.

Rotate the actuator counterclockwise so that the knock pin slides to the end of the hole as shown in the illustration.


i.

Install the bolts.

Torque:
26.5 N*m (270 kgf*cm, 20 ft.*lbf)


j.

Connect the differential lock actuator connector.


k.

Connect the rear differential lock actuator breather hose to the differential actuator assembly.