This DTC is stored if the navigation receiver assembly judges that the signals or signal lines between the rear television camera assembly, and the navigation receiver assembly are not normal as a result of its self check.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1622 | Open or short in the rear television camera assembly signal circuit | ·
Harness or connector ·
Rear television camera assembly ·
Navigation receiver assembly ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output (for Navigation Receiver Type) | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Disconnect the v3*1 or X10*2 rear television camera assembly connector.
*1: w/ Tire Carrier
*2: w/o Tire Carrier
Disconnect the H55 navigation receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| v3-6 (CB+) - H55-11 (CA+) | Always | Below 1 Ω |
| v3-3 (CV+) - H55-12 (V+) | Always | Below 1 Ω |
| v3-2 (CV-) - H55-24 (V-) | Always | Below 1 Ω |
| v3-5 (CGND) - H55-23 (CGND) | Always | Below 1 Ω |
| v3-6 (CB+) or H55-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| v3-3 (CV+) or H55-12 (V+) - Body ground | Always | 10 kΩ or higher |
| v3-2 (CV-) or H55-24 (V-) - Body ground | Always | 10 kΩ or higher |
| v3-5 (CGND) or H55-23 (CGND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| X10-6 (CB+) - H55-11 (CA+) | Always | Below 1 Ω |
| X10-3 (CV+) - H55-12 (V+) | Always | Below 1 Ω |
| X10-2 (CV-) - H55-24 (V-) | Always | Below 1 Ω |
| X10-5 (CGND) - H55-23 (CGND) | Always | Below 1 Ω |
| X10-6 (CB+) or H55-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| X10-3 (CV+) or H55-12 (V+) - Body ground | Always | 10 kΩ or higher |
| X10-2 (CV-) or H55-24 (V-) - Body ground | Always | 10 kΩ or higher |
| X10-5 (CGND) or H55-23 (CGND) - Body ground | Always | Below 1 Ω |
OK
NG
Remove the navigation receiver assembly with the connector still connected (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>REMOVAL).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H55-11 (CA+) - H55-23 (CGND) | Engine switch on (ACC) | 5.5 to 7.05 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H55-23 (CGND) - Body ground | Always | Below 1 Ω |
| *a | Component with harness connected
(Navigation Receiver Assembly) |
OK
NG
| *a | Component with harness connected
(Navigation Receiver Assembly) |
*b | Waveform 1 |
| *c | Waveform 2 | *d | Synchronization Signal |
| *e | Video Waveform | - | - |
Remove the navigation receiver assembly with the connector still connected (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>REMOVAL).
Check the waveform of the rear television camera assembly using an oscilloscope.
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly with the connector connected.
| Item | Content |
|---|---|
| Measurement terminal | H55-12 (V+) - H55-24 (V-) |
| Measurement setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Waveform 1: Engine starts, shift lever in R, camera lens is not covered, displaying an image.
Waveform 2: Engine starts, shift lever in R, camera lens is covered, blacking out the screen. |
The video waveform changes according to the image sent by the rear television camera assembly.
The video waveform is constantly output when the engine switch is on (ACC).
Waveform is as shown in the illustration.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Tire Carrier) | B |
| NG (w/o Tire Carrier) | C |
A
B
C