Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU) › 2017.08–2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261016 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  Image from Camera for Parking Assist Monitor is Abnormal  


DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the navigation receiver assembly.

WIRING DIAGRAM

E323600E05
5.365,2.729 6.906,3.104 1.542,0.375 10 false Rear Television Camera Assembly 5.365,2.552 6.969,2.729 1.604,0.177 10 false v3*1, x10*2 0.969,2.688 2.198,3.146 1.229,0.458 10 false Navigation Receiver Assembly 0.271,4.375 1.25,4.542 0.979,0.167 10 false *3: Shielded 0.271,4.094 1.583,4.26 1.313,0.167 10 false *2: w/o Tire Carrier 0.271,3.813 1.583,3.979 1.313,0.167 10 false *1: w/ Tire Carrier 0.969,2.531 1.438,2.708 0.469,0.177 10 false H55 5.563,2.167 6.281,2.344 0.719,0.177 10 false CGND 5.542,1.646 6.26,1.823 0.719,0.177 10 false CV- 5.542,1.146 6.26,1.323 0.719,0.177 10 false CV+ 5.542,0.656 6.26,0.833 0.719,0.177 10 false CB+ 1.521,2.146 2.24,2.323 0.719,0.177 10 false CGND 1.781,1.646 2.5,1.823 0.719,0.177 10 false V- 1.74,1.146 1.958,1.323 0.219,0.177 10 false V+ 1.646,0.646 2.365,0.823 0.719,0.177 10 false CA+ 5.354,2.031 6.073,2.208 0.719,0.177 10 false 5 5.344,1.552 6.063,1.729 0.719,0.177 10 false 2 5.344,1.042 6.063,1.219 0.719,0.177 10 false 3 5.344,0.542 5.656,0.719 0.313,0.177 10 false 6 2.063,2.031 2.781,2.208 0.719,0.177 10 false 23 2.635,2.302 2.958,2.479 0.323,0.177 10 false *3 3.063,2.302 3.385,2.479 0.323,0.177 10 false *3 3.5,2.302 3.823,2.479 0.323,0.177 10 false *3 3.896,2.302 4.219,2.479 0.323,0.177 10 false *3 4.354,2.302 4.677,2.479 0.323,0.177 10 false *3 4.781,2.302 5.104,2.479 0.323,0.177 10 false *3 2.073,1.563 2.792,1.74 0.719,0.177 10 false 24 2.063,1.052 2.781,1.229 0.719,0.177 10 false 12 2.052,0.531 2.771,0.708 0.719,0.177 10 false 11

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>CALIBRATION).



HINT:

Images may be unclear even in normal conditions if:

·

Electrical devices are used in the cabin (noise may occur in the image).

·

Accessories that generate radio waves have been installed (noise may occur in the image).

·

The outer mirror switch assembly is operated (noise may occur in the image).

·

The navigation receiver assembly is cold (the image immediately after turning the engine switch on (IG) may be blurred or darker than normal).

·

The camera lens is dirty with snow, mud, etc.

·

A strong beam of light, such as a sunbeam or headlight, hits the camera.

·

It is too dark around the camera (at night etc.).

·

The ambient temperature around the camera is either too high or too low.

·

The vehicle is tilted at a steep angle.

·

The rear television camera assembly lens is scratched.

·

The rear television camera assembly lens has drops of water on it or the humidity is high.

·

When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)
a.

Disconnect the v3*1 or X10*2 rear television camera assembly connector.

*1: w/ Tire Carrier

*2: w/o Tire Carrier



b.

Disconnect the H55 navigation receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
w/ Tire Carrier:
Tester Connection Condition Specified Condition
v3-6 (CB+) - H55-11 (CA+) Always Below 1 Ω
v3-3 (CV+) - H55-12 (V+) Always Below 1 Ω
v3-2 (CV-) - H55-24 (V-) Always Below 1 Ω
v3-5 (CGND) - H55-23 (CGND) Always Below 1 Ω
v3-6 (CB+) or H55-11 (CA+) - Body ground Always 10 kΩ or higher
v3-3 (CV+) or H55-12 (V+) - Body ground Always 10 kΩ or higher
v3-2 (CV-) or H55-24 (V-) - Body ground Always 10 kΩ or higher
v3-5 (CGND) or H55-23 (CGND) - Body ground Always Below 1 Ω

w/o Tire Carrier:
Tester Connection Condition Specified Condition
X10-6 (CB+) - H55-11 (CA+) Always Below 1 Ω
X10-3 (CV+) - H55-12 (V+) Always Below 1 Ω
X10-2 (CV-) - H55-24 (V-) Always Below 1 Ω
X10-5 (CGND) - H55-23 (CGND) Always Below 1 Ω
X10-6 (CB+) or H55-11 (CA+) - Body ground Always 10 kΩ or higher
X10-3 (CV+) or H55-12 (V+) - Body ground Always 10 kΩ or higher
X10-2 (CV-) or H55-24 (V-) - Body ground Always 10 kΩ or higher
X10-5 (CGND) or H55-23 (CGND) - Body ground Always Below 1 Ω




OK

2.CHECK REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK REAR TELEVISION CAMERA ASSEMBLY

b.

Check that the parking assist monitor system operates normally.

OK:

Parking assist monitor system operates normally.




OK

END (REAR TELEVISION CAMERA ASSEMBLY IS DEFECTIVE)

NG