Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM › from 2017.08
RM27T0E _55 Steering _053718 STEERING COLUMN _0260955 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM C

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  B2624  Vehicles Speed Malfunction  


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems via CAN communication. Each ECU informs the other ECUs that it is connected to the network by sending a specified signal (periodic signal) onto the communication bus on a regular basis. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter assembly via the CAN communication bus to prevent improper operation of the auto away/return function while driving.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2624 Vehicles Speed Malfunction
·

The auto away function is disabled with the last vehicle speed signal (If the ignition switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).) of 10 km/h (6 mph) or more.

·

The vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.


·

CAN communication system

·

Meter / gauge system

·

Multiplex tilt and telescopic ECU



PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)

Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS (FREEZE SPEED INFO)

NG

2.READ VALUE USING GTS (FREEZE SPEED INFO)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Check the vehicle speed signal on the GTS.


f.

Enter the following menus: Body Electrical / Tilt & Telescopic / Data List.

Body Electrical > Tilt&Telescopic > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Freeze Speed Info Vehicle speed data Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed -

Result:
Result Proceed to
Values indicated on the GTS are normal. A
Values indicated on the GTS are abnormal. B


HINT:

A vehicle speed of 3 km/h (2 mph) or more may be displayed on the GTS immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal received via CAN communication and is not a malfunction.




A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU

B