Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75444E
1.INSTALL FRONT FENDER PLATE LH
When installing the front fender plate LH, heat the front fender plate LH and vehicle body using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Front Fender Plate LH | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body or front fender plate LH excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
Install a new front fender emblem.
Using a heat light, heat the vehicle body and a new front fender plate LH.
Remove the peeling paper from the face of the front fender plate LH.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Install the front fender plate LH in the position shown in the illustration.
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | *b | Fender Relief |
| *c | Fender End Line | *d | 47.7 mm (1.88 in.) |
| *e | 43.7 mm (1.72 in.) | *f | 113.2 mm (4.46 in.) |
| *g | 112.6 mm (4.43 in.) | *h | 153.9 mm (6.06 in.) |
| *i | 44.6 mm (1.76 in.) | *j | 60.1 mm (2.37 in.) |
| *k | 117.5 mm (4.63 in.) | *l | 110.6 mm (4.35 in.) |
| *m | 61.7 mm (2.43 in.) | - | - |