Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › PARTICULATE MATTER SENSOR › from 2018.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0359256 PARTICULATE MATTER SENSOR A

1GD-FTV ENGINE CONTROL  PARTICULATE MATTER SENSOR  REMOVAL  


PROCEDURE

Hide 89439K 1.REMOVE NO. 3 SENSOR BRACKET

A424372

a.

Remove the 2 bolts and No. 3 sensor bracket.


Hide 894A0 2.REMOVE PARTICULATE MATTER SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A424373

Remove the 2 bolts, detach the connector and 2 clamps, and then disconnect the harness and controller portion (exhaust sensor clamp bracket).


b.
A424374N01
1.313,1.594 1.479,1.594 1.479,1.594 1.813,0.938 true 1.042,1.531 1.365,1.708 0.323,0.177 10 true SST

Using SST, remove the particulate matter sensor.

SST
09224-00030  


c.
A424375

Remove the 2 nuts, detach the 2 clamps, and then remove the particulate matter sensor from the exhaust sensor clamp bracket.