Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › PARTICULATE MATTER SENSOR › from 2018.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0359256 PARTICULATE MATTER SENSOR A

1GD-FTV ENGINE CONTROL  PARTICULATE MATTER SENSOR  INSTALLATION  


PROCEDURE

Hide 894A0 1.INSTALL PARTICULATE MATTER SENSOR

a.

Install the particulate matter sensor with the 2 nuts to the exhaust sensor clamp bracket, and attach the 2 clamps.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.
A424376C01
1.938,0.802 2.156,0.448 2.156,0.448 2.333,0.448 true 0.875,0.656 1.094,0.844 0.219,0.188 10 true *a 2.427,0.375 2.76,0.531 0.333,0.156 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the particulate matter sensor.

SST
09224-00030  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 40 mm (1.58 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 43.2 N*m (441 kgf*cm, 32 ft.*lbf)




c.

Install the controller portion (exhaust sensor clamp bracket) with the 2 bolts, and then attach the connector and 2 clamps.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Complete the installation so that there is no tension or slack in the harness of the particulate matter sensor, and there is no interference.



Hide 89439K 2.INSTALL NO. 3 SENSOR BRACKET

a.

Install the No. 3 sensor bracket with the 2 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)