Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › from 2018.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260460 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  REMOVAL  


PROCEDURE

Hide 25051 2.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 89463C 3.REMOVE NO. 1 NITROGEN OXIDES SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A424388N01
2.458,1.698 2.302,1.698 2.302,1.698 1.677,1.01 true 2.542,1.646 3,1.844 0.458,0.198 10 false SST

Using SST, remove the No. 1 nitrogen oxides sensor.

SST
09224-00012  


b.
A424385

Remove the 2 nuts, detach the clamp (cable tie), and then remove the No. 1 nitrogen oxides sensor from the exhaust sensor clamp bracket.


Hide 89463D 4.REMOVE NO. 2 NITROGEN OXIDES SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A424378

Remove the 2 bolts, detach the connector and 5 clamps, and then disconnect the harness and controller portion (exhaust sensor clamp bracket).


b.
A424379N01
0.573,1.271 0.729,1.271 0.729,1.271 1.104,0.948 true 0.26,1.208 0.552,1.375 0.292,0.167 10 true SST

Using SST, remove the No. 2 nitrogen oxides sensor.

SST
09224-00012  


c.
A424380

Remove the 2 nuts, detach the 2 clamps, and then remove the No. 2 nitrogen oxides sensor from the exhaust sensor clamp bracket.