12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Detach the 2 front clips of the No. 1 engine cover sub-assembly.
| *A | w/o Urea SCR System | *B | w/ Urea SCR System |
While pulling the No. 1 engine cover sub-assembly towards the front, detach the 2 rear pins, and then remove the No. 1 engine cover sub-assembly.
2.DRAIN ENGINE COOLANT
17342F
3.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)
Slide the 2 clips and disconnect the oil return hose.
Loosen the 2 hose clamps and remove the No. 2 intercooler air hose.
17360A
4.REMOVE AIR TUBE ASSEMBLY (w/o Urea SCR System)
Detach the clamp and disconnect the No. 1 fuel hose from the air tube support bracket.
Remove the 3 bolts and air tube support bracket.
Disconnect the connector from the intake air temperature sensor.
Loosen the hose clamp and remove the air tube assembly from the diesel throttle body assembly.
17030
5.REMOVE AIR HOSE ASSEMBLY (w/ Urea SCR System)
77246C
6.REMOVE FUEL MAIN TUBE SUPPORT (w/ Urea SCR System)
Detach the 2 clamps and disconnect the No. 1 fuel hose and breather hose from the fuel main tube support.
Remove the bolt and fuel main tube support from the diesel throttle body assembly.
26100G
7.REMOVE DIESEL THROTTLE BODY ASSEMBLY
w/o Urea SCR System:
Remove the 2 bolts and 2 nuts, disconnect the diesel throttle body assembly, and then remove the gasket.
Disconnect the connector.
Detach the clamp, disconnect the emission control valve wire from the wire harness clamp bracket, and then remove the diesel throttle body assembly. (except Cold Area Specification Vehicles)
Detach the clamp, and then disconnect the emission control valve wire from the wire harness clamp bracket. (for Cold Area Specification Vehicles)
Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose and remove the diesel throttle body assembly. (for Cold Area Specification Vehicles)
Disconnect the connector to remove the emission control valve wire from the diesel throttle body assembly.
w/ Urea SCR System:
Disconnect the connector and clamp from the intake air temperature sensor and wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket from the air intake connector.
Remove the 4 bolts, air intake connector and 2 gaskets, and then disconnect the diesel throttle body assembly.
Disconnect the connector.
Detach the clamp, and then disconnect the emission control valve wire from the wire harness clamp bracket.
Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose and remove the diesel throttle body assembly.
Disconnect the connector to remove the emission control valve wire from the diesel throttle body assembly.