Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2018.06
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0260625 DIFFERENTIAL PRESSURE SENSOR G

1GD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89481B 1.INSPECT DIFFERENTIAL PRESSURE SENSOR

a.

Connect the GTS to the DLC3.


b.

w/o Urea SCR System:

Remove the No. 1 engine cover sub-assembly.


c.

Slide the clamp and disconnect the air hose from the differential pressure sensor.


d.
A352180E02
1.156,2.26 1.156,1.958 1.156,1.958 1.323,1.958 true 1.365,1.875 1.719,2.063 0.354,0.188 10 true SST

Install SST to the differential pressure sensor.

SST
09992-00242  


e.

Turn the ignition switch to ON.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Data List / DPF Differential Pressure.


h.
A346677E02
2.01,3.167 2.24,3.365 0.229,0.198 10 true *a

Apply pressure to the differential pressure sensor assembly.

Text in Illustration
*a Pressure


i.

Check the pressure value of the differential pressure sensor.

Standard pressure:

Approximately the same pressure as the applied pressure is indicated on the GTS.


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the differential pressure sensor circuit.


j.

Remove SST from the differential pressure sensor.


k.

Connect the air hose to the differential pressure sensor, and slide the clamp to secure the hose.


l.

w/o Urea SCR System:

Install the No. 1 engine cover sub-assembly.