Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › from 2017.08
RM27T0E _54 Brake _053712 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0260916 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.


PROCEDURE

Hide 84306 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

Hide 89245B 2.INSTALL STEERING SENSOR

a.
C418670C01
3.229,1.833 3.229,1.115 3.229,1.115 2.896,1.115 true 2.292,1.281 2,2.021 2,2.021 1.833,2.021 true 1.115,0.656 0.698,0.281 0.698,0.281 0.49,0.281 true 0.708,1.021 0.51,0.573 0.51,0.573 0.344,0.573 true 2.281,0.917 1.885,0.708 1.885,0.708 1.719,0.708 true 1.51,0.604 1.719,0.802 0.208,0.198 10 false *a 3.156,1.875 3.406,2.125 0.25,0.25 10 false *b 0.292,0.188 0.625,0.427 0.333,0.24 10 false *c 1.552,1.927 1.76,2.125 0.208,0.198 10 false *a 0.146,0.469 0.396,0.719 0.25,0.25 10 false *b
*a Guide
*b Pin
*c Lock Pin


Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.

·

The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C418671

Remove the lock pin from the steering sensor.


Hide 3.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY