When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
Do not touch the camera lens or the front windshield glass in front of the camera.
If the forward recognition camera has been struck or dropped, replace it with a new one.
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also, the dynamic radar cruise control system, front camera system, lane departure alert system, road sign assist system, pre-collision system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.
86466E
1.REMOVE NO. 2 FORWARD RECOGNITION COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the 2 claws in the direction indicated by the arrow (1) in the illustration.
If the 2 claws are detached separately they may become damaged. Therefore, remove them at the same time.
Detach the 2 guides in the direction indicated by the arrow (2) in the illustration to remove the No. 2 forward recognition cover.
86466D
2.REMOVE NO. 1 FORWARD RECOGNITION COVER
|
Remove in this Direction |
Detach the 2 clips and 2 guides and remove the No. 1 forward recognition cover as shown in the illustration.
When removing, press the cover parallel to the windshield glass surface and remove.
86464A
3.REMOVE FORWARD RECOGNITION LATCH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the 2 claws in the direction indicated by the arrow (1) in the illustration.
Detach the 4 guides in the direction indicated by the arrow (2) in the illustration to remove the forward recognition latch.
8646C
4.REMOVE FORWARD RECOGNITION CAMERA
If the forward recognition camera has been struck or dropped, replace it with a new one.
|
Remove in this Direction |
Disconnect the connector.
Do not pull the harness forcibly when disconnecting the connector.
Detach the 4 guides and remove the forward recognition camera as shown in the illustration.
Do not apply excessive force.
If the forward recognition camera bracket is deformed or damaged, replace it together with the windshield glass.