Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
84010A
3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts.
Pull the radio and display receiver assembly with bracket to detach the 7 clips, 2 guides on the backside of the radio and display receiver assembly with bracket.
Disconnect each connector and remove the radio and display receiver assembly with bracket.
86211J
5.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 1 radio receiver bracket.
86212C
6.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 3 screws and No. 2 radio receiver bracket.
55670A
7.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
Detach the 7 claws and remove the center instrument panel register assembly.
86140A
8.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY