Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
84010A
3.REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY
4.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH NAVIGATION ECU
Remove the 4 bolts.
Pull the radio and display receiver assembly with navigation ECU to detach the 7 clips, 2 guides on the backside of the radio and display receiver assembly with navigation ECU.
86842
5.REMOVE NO. 1 NAVIGATION WIRE
Disconnect the 3 connectors and remove the No. 1 navigation wire.
86841
6.REMOVE NAVIGATION ECU
Remove the 8 screws.
Remove the navigation ECU as shown in the illustration.