Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY › from 2020.08
RM27T0E _57 Power Source / Network _053728 POWER DISTRIBUTION _0328752 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E379431C01
1.563,0.969 1.563,0.635 true 1.469,0.958 1.667,1.135 0.198,0.177 10 false *a
*a Lock


Push the lock to detach the No. 1 relay block cover.


b.

Detach the 2 claws while lifting up the No. 1 relay block cover to remove it.


Hide 82641 4.REMOVE NO. 1 INTEGRATION RELAY

a.

except 5L-E:

i.
E379430C01
2.375,0.948 2.74,0.948 true 1.625,1.25 1.625,1.698 true 2.75,0.854 2.948,1.021 0.198,0.167 10 true *a 1.531,1.688 1.729,1.854 0.198,0.167 10 false *a
*a No. 1 Integration Relay Fixing Lock


While pushing the No. 1 integration relay fixing lock shown in the right illustration toward the center, pull the No. 1 integration relay upwards.


ii.
E378099

Disconnect the 5 connectors from the No. 1 integration relay and remove it.

NOTICE:

Do not drop the No. 1 integration relay or subject it to any strong impacts. Additionally, do not use a No. 1 integration relay that has been dropped.




b.

for 5L-E:

i.
B236388C04
1.323,0.167 1.063,0.167 1.063,0.167 0.656,0.313 false 2.229,0.146 2.438,0.146 2.438,0.146 2.865,0.281 false 1.354,0.063 1.531,0.219 0.177,0.156 10 false *a 2.063,0.063 2.24,0.219 0.177,0.156 10 false *a
*a Protective Tape


Using a screwdriver, detach the 2 claws and disconnect the No. 1 integration relay from the engine room junction block.

HINT:

Tape the screwdriver tip before use.