Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD › from 2020.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261094 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 45187 3.REMOVE LOWER NO. 3 STEERING WHEEL COVER

a.
B238307

Detach the 2 claws and remove the cover.


Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

a.
B238308E01
0.11,0.036 0.303,0.251 0.193,0.214 10 *A 0.108,2.079 0.301,2.293 0.193,0.214 10 *B

Detach the 2 claws and remove the cover.

Text in Illustration
*A w/o Cruise Control System
*B w/ Cruise Control System


Hide 45130 5.REMOVE STEERING PAD

a.

Using a T25H "TORX" driver, push in the torsion spring to detach the 3 pins and remove the steering pad.

NOTICE:
·

Do not drop the steering pad.

·

When disconnecting the steering pad, do not pull the airbag wire harness.



HINT:

Insert the T25H "TORX" screwdriver into the installation areas of the lower No. 2 steering wheel cover and lower No. 3 steering wheel cover.


B427360


b.
B420300E01
0.792,2.802 1.51,3.042 true 1.573,3 1.802,3.198 0.229,0.198 10 false *a

Tilt the steering pad toward the seat and support it with one hand.


c.

Disconnect the horn connector.


d.

Using a screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*a Connector Lock
V100155

Protective Tape

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


HINT:
·

Use the same procedure to disconnect the airbag connector on the other side.

·

Tape the screwdriver tip before use.