Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › from 2020.08
RM27T0E _58 Vehicle Interior _053737 SEAT _0261115 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:

If the side airbag was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly.


Hide 72128A 3.REMOVE FRONT SEAT INNER TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the seat to the rearmost position.


b.
B241794

Using a moulding remover, detach the 2 claws.


c.

Move the front seat inner track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the front seat inner track bracket cover LH.


Hide 72124 4.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH

a.
B239528

Using a moulding remover, detach the 2 claws.


b.

Move the front seat outer track bracket cover LH in the direction of the arrow to detach the 2 claws and guide and remove the front seat outer track bracket cover LH.


Hide 72158 5.REMOVE INNER SEAT TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the seat to the foremost position.


b.
B238099

Using a moulding remover, detach the 2 claws.


c.

Move the inner seat track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the inner seat track bracket cover LH.


Hide 72138B 6.REMOVE SEAT TRACK COVER LH

a.
B238101

Using a moulding remover, detach the 2 claws.


b.

Move the seat track cover LH in the direction of the arrow to detach the 4 guides and remove the seat track cover LH.


Hide 7.REMOVE FRONT SEAT ASSEMBLY

a.
B238103

Remove the 2 bolts.


b.

Operate the power seat switch (slide switch) to move the seat to the rearmost position.


c.
B239529

Remove the 2 bolts.


d.

Operate the power seat switch (slide switch) to move the seat to the center position, and operate the power seat switch (reclining switch) to move the seatback to the upright position.


e.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the battery negative (-) terminal to disable the SRS system.



f.

Disconnect the connectors under the seat.


g.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.