Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Walk in Seat Type) › from 2020.08
RM27T0E _58 Vehicle Interior _053737 SEAT _0261132 FRONT SEAT ASSEMBLY(for Walk in Seat Type) A

SEAT  FRONT SEAT ASSEMBLY(for Walk in Seat Type)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:

If the side airbag was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest.


Hide 72127A 4.REMOVE FRONT SEAT INNER TRACK BRACKET COVER RH

B241182

a.

Operate the seat track adjusting handle to move the seat to the rearmost position.


b.

Using a moulding remover, detach the 2 claws and remove the cover.


Hide 72123A 5.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER RH

B241185

a.

Using a moulding remover, detach the 2 claws.


b.

Move the cover in the direction of the arrow to detach the guide and remove the cover.


Hide 72157A 6.REMOVE INNER SEAT TRACK BRACKET COVER RH

B241188

a.

Operate the seat track adjusting handle to move the seat to the foremost position.


b.

Using a moulding remover, detach the 2 claws.


c.

Move the cover in the direction of the arrow to detach the 2 guides and remove the cover.


Hide 72137B 7.REMOVE SEAT TRACK COVER RH

B241186

a.

Using a moulding remover, detach the 2 claws.


b.

Move the cover in the direction of the arrow to detach the 2 guides and remove the cover.


Hide 8.REMOVE FRONT SEAT ASSEMBLY

a.
B241190

Remove the 2 bolts.


b.

Operate the seat track adjusting handle to move the seat to the rearmost position.


c.
B241191

Remove the 2 bolts.


d.

Operate the seat track adjusting handle to move the seat to the center position, and operate the reclining adjusting handle and move the seatback to the upright position.


e.

Disconnect the connectors under the seat.


f.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.