Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2TR-FE) › from 2020.08
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261181 COMPRESSOR(for 2TR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2TR-FE)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

a.
E445435

Install the magnet clutch stator with the parts aligned as shown in the illustration.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing outward.

NOTICE:

When installing the snap ring, do not widen it excessively.



c.

Attach the connector clamp.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:
·

Do not damage the seal cover of the bearing when installing the snap ring.

·

When installing the snap ring, do not widen it excessively.




e.

Install the magnet clutch washer and magnet clutch hub.

NOTICE:

Do not change the combination of magnet clutch washer used before disassembly.



f.
E445436E01
0.479,0.417 1.073,0.417 false 0.177,0.333 0.625,0.583 0.448,0.25 10 false SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.



Hide 2.INSTALL COOLER BRACKET

a.

for Type A:

i.
E445433

Install the cooler bracket with the screw.


ii.

Attach the clamp.



b.

for Type B:

i.
E447376C01
0,0 0,0 false
V100135

Connector
V100136

Screw


Install the cooler bracket with the screw.


ii.

connect the connector.


iii.

Attach the clamp.



Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

a.
E445437C02
2.219,4.208 2.667,4.208 false 0.146,0.24 0.458,0.396 0.313,0.156 10 false *a 2.031,4.135 2.344,4.333 0.313,0.198 10 false *b
*a Component without harness connected
(Magnet Clutch Assembly)
*b Battery


Clamp the cooler compressor in a vise between aluminum plates.


b.

Set a dial indicator to the magnet clutch hub.


c.

Connect the battery positive (+) lead to terminal 3 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire and measure the clearance.

Standard clearance:

0.30 to 0.55 mm (0.012 to 0.022 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

NOTICE:

Adjustment should be performed with 3 magnet clutch washers or less.



d.

Remove the cooler compressor from the vise.