Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › 2020.08–2021.06
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260461 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P203F7B  Reductant Level Too Low Low Fluid Level  


DESCRIPTION

The urea SCR system purifies NOx using urea solution.

When the remaining quantity of urea solution is running low, the system can no longer purify NOx.

Therefore, the remaining distance that can be driven is displayed on the multi-information display. When the remaining drivable distance reaches 0 km/h (0 mile), the engine cannot be started.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P203F7B Reductant Level Too Low Low Fluid Level Remaining amount of urea solution is equal to or less than a fixed amount.
(1 trip detection logic)
Refill the urea solution Does not come on DTC stored SAE Code: P203F

HINT:

When urea solution is refilled enough to increase the drivable distance to 2400 km/h (1500 mile) or more, the warning message on the multi-information display can be cleared.


CAUTION / NOTICE / HINT

NOTICE:

Perform this procedure in an environment that is warmer than -11°C (12.2°F). Otherwise, the urea solution will not freeze.


HINT:

P203F7B is output when the remaining quantity of urea solution falls below the fixed value. Therefore, refill the urea solution according to the display on the multi-information display, clear the DTC and return the vehicle to the customer.


PROCEDURE

1.REFILL UREA SOLUTION
a.

Stop the vehicle on a level surface and completely refill with urea solution.

Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>UREA TANK>REFILL

HINT:

For the urea solution, use AdBlue (conforming to ISO 22241-1).



Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes / Clear.


d.

Press the YES button.


Result:
Proceed to
NEXT



NEXT

END