This circuit is from the parking brake switch assembly to the radio and display receiver assembly.
Display the "Vehicle Signal Check Mode" screen.
Check that the display changes between ON and OFF according to the parking brake operation.
| Parking Brake Condition | Display |
|---|---|
| Applied | ON |
| Released | OFF |
This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H93 radio and display receiver assembly connector.
Disconnect the G77 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H93-20 (PKB) - G77-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake switch assembly.
Inspect the parking brake switch assembly.
Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG