The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Disconnect the H99 radio and display receiver assembly connector.
Disconnect the H98 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H99-2 (US1-) - H98-2 (UDO-) | Always | Below 1 Ω |
| H99-3 (US1+) - H98-3 (UDO+) | Always | Below 1 Ω |
| H99-5 (USG1) - H98-5 (UJSS) | Always | Below 1 Ω |
| H99-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| H99-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| H99-5 (USG1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG